nope still running 1.28. Wish I could skip it...

 I have updated to V1.29 and I have no issues with the update.  The only thing it has is a disclaimer for not being responsible for damages from the software.  If you read the manual that came with your Maxisys, the same disclaimer is in the front matter.  It doesn't really matter that the disclaimer is shown in V1.29 because anyone who has used the scanner in the past has already agreed to the disclaimer from the manual.  I think that it was bad timing on Autel's part because of all the software issues they are having. I just hit don't show again and forgot about the disclaimer.

 Any issues reinstalling old software? Saw a post in usa for ford gm mazda updates. Not able to reinstall prev ford after update.

 I have no problems going back on vehicle software on version 1.29

 thanks for the info. I always feel like i am one  update away from disaster. I will keep watching to posts before i update.

Updated it about a week ago. So far no problems and when online always info about which software has updates waiting.

Cannot say for a 100% that there is no issue whatsoever since it has been too short a period to make that sure.

 Yes I agree the spell check doesn't work, red lines everywhere under correct words..........................Support has to do something about it.................

Yes have updated to v1.29 I have no problem so far. However I was very hesitant to do
so .with all this update problem